Is the new chastity device possibly sized incorrectly or tightened up?

Hi there. I recently picked up a cheaper knockoff version in a smaller size. It’s much simpler to slide into, and the pinch points are easy enough to manage. All things considered, it feels very comfortable and hides well under everyday clothes. My only gripe is what happens when I get an erection. With my other devices, they sometimes feel awkward or even painful—but pleasantly so. This one, however, feels like it’s digging into me and pulling at my balls. Does that sound normal? Perhaps I’ve gotten used to my older, longer model which kept me locked up but still allowed for most erections. It gets quite uncomfortable when hard; last night it woke me up and refused to subside. I got a bit worried and took it off. Afterward, I had an intense erection that lasted two hours and felt great. Still, I’m concerned about potential damage since this one is smaller than my others.

I believe the base ring measures around 45mm, compared to my previous 50mm one. The overall length seems closer to 2.5 inches rather than the oversized 4” I had before. Any insights? Is it supposed to be that uncomfortable when erect despite being snug and comfortable while soft?

You’ll find better results with nocturnal erections if the fit is closer to your flaccid size, though they might not be entirely painless at first until you adjust. I suspect the 45mm ring could indeed be a bit too tight for you. Can you manage to slide one finger inside it while wearing it?

I doubt I could fit anything between the ring and my skin. It’s snug but comfortable when soft. However, in this specific cage, erections would definitely feel unwanted compared to before.

From my experience, if the base ring is too tight, it acts like a cockring and traps blood for longer periods. Trapped blood over long durations can become problematic, especially if your skin starts turning blue or purple. Here’s what I think makes for a perfect fit on a ball trap cage: The cage length and diameter should match your normal flaccid size closely (some people subtract half an inch from the length). There needs to be enough gap so your balls don’t pop through, and the base ring ought to sit snugly against you while soft but still allow one finger underneath. I’m no expert, but that’s what I’ve gathered over the years.

That sounds like exactly what is happening. I haven’t noticed any color changes or cold spots, which I know are things to look out for. However, when my erection reaches full size and exceeds half its length, it takes a long time to go down. Once it hits that peak point, I usually take the device off just to be safe. It’s a pity because aside from that issue, it is very easy to wear and conceal. Perhaps I should increase the ring diameter by a few millimeters.

> member_bc87d71103 wrote: > I think that's what's happening. Haven't noticed any color changing or cold areas which I've heard to watch out for. But when I get full size and more than half chub it takes a long time to come back down. When it hits that point i generally take it off to be safe. It's a shame cuz other than that it's very easy to wear and conceal. > > Maybe I just need to go up a few mms You are likely spot on. We have experimented with several different chastity belt devices. The problem for us is that my balls are quite small; even with the CB6000s, using their smallest ring and pin, they still manage to slip out. A Holy Trainer should arrive tomorrow. Based on all I’ve read, finding what works often comes down to investing in different devices until you find your match.