Mature Metal discussion

I recently received my updated jailbird after it was resized. Initially, the tip of my penis couldn’t quite touch the bars when flaccid. I had three-quarters of an inch removed, which appears to have fixed that issue.

One thing I’ve noticed is that because I’m a grower, extra skin tends to poke through the bars. This often gets rubbed awkwardly in the jeans I usually wear, particularly where the zipper and inseam meet up. As a result, the skin on the left side of my shaft gets pinched against the bars. For now, I seem to have sorted this out by wearing panty liners or stuffing tissue paper inside.

I used the sizing rings for reference and chose 1 3/8 inches (my shaft was snug, but there was some looseness around the head area).

Honestly, apart from that one issue, it feels great. Has anyone else dealt with this? Should I opt for a wider diameter next time, even though it would be looser near the head? Or is there a better type of pants I should consider investing in?

For reference, here are the dimensions I went with: 2 3/4 inches length 1 3/8 inch diameter 3/8th gap 13/16 inch base ring [[Image: IMG_3851.JPG]](the referenced community page) [[Image: IMG_3842.JPG]](the referenced community page)

Hiya The answer is actually in your question, as teachers always say. My bits and pieces also rub against the seam and zipper of my jeans! It's an unhygienic and uncomfortable setup at the best of times. Underwear has been available for quite some time now from many shops in towns and cities across England, and I believe it's available in other countries too. If not, you might see them pegged up on washing lines if you look over garden fences. Depending on where you live, try using some pants or knickers to protect your boy bits from wear and tear, which obviously saves having to wash your trousers every day. It’s a necessary bit of discipline unless one is very particular about bathroom habits. I’d suggest that comfortable full briefs would be best; pink ones are the softest against the skin and go a long way in preventing further chafing—and I might add unnecessary chafing—of your rather delicate boy bits. Also, you can change them daily, which significantly reduces the laundry load and greatly improves hygiene while stopping bad smells from unwashed jeans. Xx Wendy

Thanks Wendy. I suppose I should have mentioned that I’ve been wearing tight briefs with a pouch to keep the whole package together. Even so, I still feel the rubbing through them, which is why adding panty liners has provided some relief.

Oh well, you never did say that. Xx Wendy

Are your trousers too tight in the crotch? I find that can be an issue occasionally with my JB. Another possible fix is to make sure you are wearing cotton briefs instead of thin nylon ones.

if you get some nice soft white knickers you won't have any trouble. mine are ever so soft, they feel like oooh lovely.

Thanks Jemima and Nostromo. I have been wearing cotton briefs similar to this: (and with an added panty liner for cushioning) I don't think my pants are particularly tight in the crotch, but they aren't sweatpants either. Does your skin get bunched up like mine does in the pictures?

I'm guessing that the shortened cage is the problem. You seem to have a lot of loose skin (I've never seen it this extent before) protruding between the bars. Did this happen at all before you had the cage shortened? An increase in cage diameter, or going back to greater length may be necessary if you can't find another solution. Another possible solution might be asking MM to add an extra ring or two into the cage to reduce the height of the cage openings.

I am thinking a possible solution would be to move the end ring back slightly to just behind the gland. There is quite a bit more skin than normal here. The ring floats freely so it should be easy to try.