For sale/wanted (Please be aware of scams) discussion

Hey everyone, I’m listing my Steelworxx Tube Jacket for sale, including the extra bars. I wanted to offer it here first before putting it up on eBay. It’s the same model shown in this link below, just a more compact size: thought i’d give you guys the chance Here are the specs: Internal Diameter: 30mm Top length: 25mm (standard) Pin diameter: 5mm The unit is brand new (I got it mid-May) and has only been worn a handful of times. I’ll make sure to clean it well before shipping. It’s a really solid piece - I’ve opted to buy a fresh one from Steelworxx rather than having this one resized, so selling the original helps cover some costs. The total came to €277 (roughly £200) with extra bars and postage included. You can grab it for £175 + shipping, without waiting four weeks for delivery. Drop me a message if interested!

[[Image: SW1.jpg]](the referenced community page) [[Image: sw2.jpg]](the referenced community page) Photos are attached... (I thought I could edit the post above to add them, but it looks like that didn't work)

Just wondering, did you find the fit too big or maybe a bit small?

I chose a standard length tube based on suggestions from this forum, but it might have been better if it were just a few millimeters longer. I could likely manage with the current size, though since I spent quite a bit, I figured getting the fit perfect was worth it.

I have three questions about this: 1: To verify my unit conversions are correct, do these dimensions look right? Internal Diameter: 1.18" (is that 1 1/8"?) Top length: .98" (measured from the PA gauge to the top of the device?) Pin diameter: 5.156mm (is this roughly 6 ga.?) 2: I own an et-312b e-stim unit, and it seems like there is plenty of skin available for attaching electrodes. Do you think it's feasible to use conductive rubber on the penis with a device like this to reach an orgasm? 3: I recently got hold of a contender from and discovered that 1 1/8" is actually too tight because it restricts blood flow back in at a good rate, leading to various bulging issues. It doesn't hurt, but the device just didn't function properly for me. Since the internal diameter here should be comparable, would I run into similar problems? Thanks beforehand.