CB Range discussion

ever since I started using this chastity belt (CB), I’ve been searching for a way to boost its security. It didn’t take long to realize that, due to its design, it’s quite easy to slip out by simply pulling on the penis and then sliding each testicle out one after another. The KSD-G3 models seemed like an excellent option because piercings intimidate me; I worry about their lasting impact (I really don’t want to have to pee in three directions at once!). However, their cost is surprisingly steep for what you get. So, I popped into the hardware store next door and picked up two inches of rubber tubing. It was crystal-clear PVC, roughly 1 inch wide with a thickness of about 0.1 inch (though other dimensions should work too). I cut out a rectangular section from it and drilled a hole to thread it around the cage’s spacer, then heated the edges slightly to stop them from pinching or hurting me. My first attempt was a bit oversized and squeezed too hard, so I trimmed off some more material (for my build, about 1.2 inches long by 0.8 inches wide is ideal). Now, my penis is truly out of reach. Plus, I experience fewer “erection attempts,” the cage shifts less, allowing me to walk around without constantly readjusting it. It also feels more secure against public exposure since it sits closer to my body. +++A nice bonus with this approach is that anyone can tweak the dimensions to fit them perfectly. As maturemetal pointed out, CBs aren’t universally sized; mine was just too large for me. +++I believe this “tube method” could also work on larger rings to protect against edge injuries!

Is it essentially a tube within another tube? I'm having trouble visualizing the setup. But if that's how it works, it sounds very much like a luv-to-lock security device. I used one of those before, and when my erection swelled up, the edge of the inner tube nearest to my body ended up creating a pressure sore. 1. It wasn't fun at all 2. Left a scar

It's not an entire continuous tube. I purchased just a segment of tubing because it was the most economical way to get PVC rubber. I sliced out a rectangular piece from that segment. It is very similar to those KSD-G3 devices, just slightly less polished in appearance (but once installed, you hardly notice). The core concept is sliding the penis into the CB while this rubber component sits on top. It keeps things locked because if the penis tries to slide back out, the rubber band catches it. You can certainly force your way out, but you'll need to pull much harder: instead of folding forward easily, the rubber has to buckle backward, and it doesn't glide as smoothly over plastic surfaces. I hope that makes sense! Just take a look at the KSD series (for example on the 'kept for her' website) and you'll see exactly what I mean.