Dominant, professional or lifestyle? Get listed on the Wanted board. Post an ad
FindMistress

Chastity device reviews discussion

I just purchased the 6kS for my partner. Because of some reviews I'd read about it being escapable if you really tried, I also picked up the G3. I went with…

member_21355b410d 29 Aug 2026 #1

I just purchased the 6kS for my partner. Because of some reviews I’d read about it being escapable if you really tried, I also picked up the G3. I went with a small size because my guy’s penis has this disappearing act sometimes. Mind you, he reaches around a solid 8 inches when grown, but in cold weather or while showering, it can shrink to under an inch, leaving behind loose skin.

We struggled a bit at first getting the fit right and putting it on correctly. Once we sorted that out, most of the pinching stopped. He mainly complains about pain during arousal phases, but I told him he just needs to get used to it.

Today, his penis got quite small in the shower—so much so that he thought soap lubrication might cause it to be pulled off entirely. The G3 wasn’t even touching his shaft at that point. Currently, he has the #2 ring on with the smallest spacer and a B-sized component for the G3.

I did try size C, but that resulted in pain and pinching.

It seems like his testicles are quite heavy, pulling down the device so it slips off his penis despite wearing the G3. Though I suppose we could go back to trying the smallest spacer again.

So here is my question: Is there a way to keep the device held up securely without sliding off? I’d prefer not having to buy an entirely new unit given current economic conditions. Thanks in advance for your help. Adabella ::Update:: The second largest ring appears to be rubbing his scrotum too much, and now it’s peeling. Is there a way to stop that?

member_3d7705e8f0 30 Aug 2026 #2

Adabella, That is the classic issue for us "growers rather than showers" when using trapped ball devices. You have to do your best with the spacers and rings. It's possible you'll reach a point where he can escape, but might not be able to get back in if that happens. Some people, myself included, have tried securing the tube by getting a PA piercing. That comes with its own issues though. I have a CB3K, which is slightly long for me when completely flaccid, causing it to pull on my piercing. As I've mentioned often before, finding the right chastity devices is usually more of a "process". Good luck to you all, and please feel free to keep watching the forums and asking for suggestions. mikecb

member_e55fab181a 31 Aug 2026 #3

I second that opinion. Keep experimenting with the spacers and rings... you might "think" you have the right fit initially, but after a while your body can adjust to it (somewhat like breaking in a corset!)

member_42991f1982 3 Sept 2026 #4

MsAdabella, this advice is spot on from very knowledgeable people. Just one note though... when I read that Your sub was 'small' but grew to 8', it made me chuckle a bit!

member_2a491127c4 4 Sept 2026 #5

If you find the right G3 size fit, there are instructions on how to bend the nylon for proper adjustment. If the size is good but the tab causes pain, you can bend the tab up or down according to the instruction sheet.

member_21355b410d 6 Sept 2026 #6

Thank you for your comment. Where would I be able to find these instructions? I didn't receive any with my G3

member_2a491127c4 8 Sept 2026 #7

Miss Adabella, they are also posted here: hope that helps. i knew i kept that site bookmarked for a reason.