Mature Metal discussion

I’m wearing a cb-6000s right now, and when I’m relaxed, the tip doesn’t engage. While measuring for a Mature Metal item, my relaxed measurement came out to one and three quarters inches. So, should I get it in a 1.5-inch cage length or stick with the 1.75-inch size?

You might find Pansy Tart's Measuring Guide in this thread helpful. Many members here have used it when sizing up for Mature Metal and found the results to be both useful and precise. I hope you get a few more replies from the guys soon.

MM advises that choosing a cage that is too short can lead to slipping out the back, so I recommend going with your most common size. The biggest complaint usually comes from men who buy cages that are too long. My fit works well for me, but if I could do it over, I’d likely shorten it by another quarter-inch.

Hi! Actually, regarding length, I think using the CB6000s as a reference is better. It seems more reliable than just using a ruler. The CB6000s measures 2 1/2" in total length. So, if you are sitting at about 3/4" from the end of the device while flaccid, order the 1 3/4" version. If your measurement is around 1", then go with the 1 1/2".

It really depends on a few factors. 1. Circumcised or uncircumcised - if you are uncut like me, you need to allow some room for the foreskin AND make sure you get the vertical bars positioned on the outside to prevent pinching (which works well). 2. "Grower vs shower" - if you’re a shower type, PT's guide is helpful, but watch out for rings that are too large – they match his specific anatomy perfectly, but since we all differ, it might not suit me personally. If you're more of a grower, keep the fit snug. The most accurate length measurement comes from MM’s website: measure the smallest flaccid length under the penis starting where it meets the scrotum without pressing the ruler deep into tissue – just have the penis resting on top. For width, use the same state. I followed these methods and my device fits perfectly.