Full Belts discussion

Hi everyone, It’s been a while since I last posted. Several months ago, I finally decided to order a Neosteel shemale sports belt. However, after it was manufactured, I sent it back for the cable lengthening because the original length didn’t allow the metal plate to connect comfortably with the crotch shield.

Since that adjustment, we’ve managed to lock and wear it for up to a day at most, but there have been issues: the penis tube digs into the underside of my penis, and the hipband also presses in uncomfortably.

After talking with Reinhold, he recommended bending the crotch shield to change how the tube rotates. This helped somewhat, though not by much. This morning, I had an idea and tried attaching the tube directly to the hipband without using the crotchshield. That’s when I realized the arm connecting the penis tube to the bolts on the hipband is about 1cm too short. To reach the bolt, the penis tube gets pulled upward, which causes it to dig into my underside.

Also, the hipband isn’t particularly tight. To reduce the digging sensation in my penis from the tube, I end up pulling the hipband down slightly below my hipbones so that the arm on the tube doesn’t have to stretch as far.

I emailed Reinhold this morning, but while waiting for his reply, I wondered if anyone else has faced a similar situation. If we drill another hole higher up on the arm attached to the penis tube, would that work? Or does it mean the crotch shield won’t fit anymore because that part also needs to be longer?

I’m starting to seriously regret bringing up chastity with my partner—and not for the usual reasons!

First question: did you measure yourself, or did Neosteel do it? I was measured in person by them. If I had done it myself, I know I would have gotten it wrong. That said, I also experienced a sore spot on top of my penis from the tube. Thinking wisely at the time, I assumed the hole was positioned too high, creating pressure on the penis. So, I drilled out the opening to allow more vertical movement as needed. Then I did some research and emailed Neosteel. Like you, he advised bending the shield, which helped significantly. It’s not unusual for things not to be perfect right away. Plus, it takes time for your body to adjust to having steel locked around it. You might well be correct; it sounds plausible. However, I would wait until Neosteel replies to your email before cutting or re-drilling holes. If you feel there is still room higher up on the arm, I think drilling another hole should be fine. The tube strap doesn’t do much other than holding the penis tube at the correct height; the stud does more of the work in keeping your penis in place. Now regarding the shield: since it has a slot, I believe it will remain suitable as is. You could always drill the new hole and see how it works out later. If you find another issue with length, you might just order a replacement penis tube in the correct size instead of sending your old one back and forth, which would save on shipping costs? That way, you can fine-tune the best fit. Just remember, I’m not an expert; I’m simply another Neosteel She-Male Belt wearer. My advice is what you paid for it—nothing wrong with that! But I wanted to let you know that others have had to make adjustments to get their belts working properly. Personally, I don’t think there’s a perfect Chasity Device out there. Every type has one or two issues, perhaps a pinch here and there. So wait for Neosteel to respond; they know what they are doing with their products. And let’s hope you resolve this so you can stay locked up as long as you wish. Good luck, Missy Tanya

Thanks for the reply. I did measure it myself using their measuring kit, so yes, there’s a good chance my measurements were off. We wanted to have them done in person, but the high cost of flying over there (at that time) put us off. I’ll continue waiting to hear from Reinhold as you suggested and see what happens next.