Chastity device reviews discussion

I finally gave in and bought a CB 6000. I’ve worn a CB 2000 for years, intermittently. I tried the Neosteel but couldn’t get past the rear cable rubbing my tailbone raw after just a few days.

The CB 6000 is very comfortable. I started with the 2-inch ring and the shortest pin plus spacer, but my left nut kept escaping like an escape artist. I switched to the 1 7/8-inch ring with the next larger pin and spacer. No more loose nuts. This combination feels great.

The new ring system makes putting on the rings much easier than with the old ones.

I’m about a 1 1/2 inches in girth when soft, so I use the sock method to guide my penis into the tube. It takes just a few minutes to get secured.

It’s not quite at the point where I forget it’s there yet, but that seems to be approaching.

Since I’m accustomed to being locked up, sleep hasn’t been an issue. I do wake up with tugs on my scrotum occasionally, so I just get up and pee. Problem solved, back to bed.

Cleanliness is a bit trickier than the CB2000 but easier than the Neosteel. I don’t fill the tube completely, which has led me to develop a technique for removing leftover urine. I roll two sheets of 2-ply toilet tissue, push them into the tube and twirl it around. This clears most of the urine and helps keep odors down. Even after two or three days, there’s no bad smell. Plus, I shower daily and make sure to get plenty of soap inside the end of the tube.

I probably should have gotten a CB 6000S since I’m a bit short when soft, and because of my girth, I don’t fill the tube well even when erect (though erection is always a hit or miss with these devices). I plan to fix that soon.

For the most part, I am wearing it 24/7 now. The only time it comes off is for cleaning and shaving.

Overall, I’m very happy with this chastity device and expect to wear it for a long while.

I just received my CB6KS tube. It feels as comfortable as the standard one. Let’s see how long I can stay in it!

One week into the CBK6S and I’m already forgetting it's there! It is far more comfortable than my CB2K.

It seems my testicles are escape artists! One day I felt like the device was loose and found both testicles had slipped out. I went down to a 1 1/2-inch ring with the smallest spacer. It took some time to get used to the tighter fit, but now it feels normal. The shorter tube fits much better. I did have to repair a split in the tube once, but it seems fine now.

I woke up this morning incredibly horny! I tried rubbing against the sheets and got enough stimulation for an erection, if you can call it that. The more I rubbed, the tighter the tube became, which reduced the stimulation even further. I even grabbed the lock to try moving the tube around. It gave me enough sensation to stay firm inside but not quite enough to reach the peak. The CB6KS is a tricky device! The harder I tried, the less satisfaction I got out of it. Felt good, yet really frustrating! I should mention that the only way I can get back in uses the old sock trick. My thickness worked against me.

Thank you! This has been very helpful. I’ve been debating getting a 6K for quite some time now.

Well, nothing stays the same. My testicles have proven to be escape artists again. I am currently using the middle ring and the second shortest pin. Surprisingly, this has turned out quite comfortable. No real tugging at night, just needing lubrication two or three times a day. There seems to be very little chafing since I haven’t seen any redness. However, I do take it off every two to three days for cleaning and shaving, but that only takes about 10 minutes.

Personally, I don’t care for the new rings on the CB6000. I had a CB3000 with solid rings and wore that without issue for over eight years. When I got the 6000, the rings were bad; they aren't round or smooth like the 3000s'. I couldn’t wear the 6000 ring for more than a day because it rubbed and burned my balls. Yes, I tried several different rings with the same result. I like the design overall, but I modified an old solid 3000 ring to fit onto the post of the 6000, and it fits perfectly.

If the CB6KS has grooves cut into its rings, that indicates a knock-off version. I have one of those knock-offs. My wife made a modification by placing rubber draft excluder tape inside the grooves so skin won't fold in. My balls are escape artists too; I was on the third ring but it was way too tight because my testicles run high and tight. For the spacer, I use the second smallest one, though I plan to go down to the smallest as my wife wants to further reduce any erections. So now that she has placed the rubber draft excluder tape on the inside of the ring (specifically the larger one), I have no escaping balls and am very comfortable. I only need lube once or twice depending on how active I am with cleaning and serving her needs, etc.

> chastesoon said: > I woke up this morning, horny as hell! Tried rubbing on the sheets, only got enough stimulation to promote a erection, if it can be called that. The more I rubbed, the tighter the tube got, and the less stimulation I was able to get. I even grabbed the lock and tried to get the tube to move. It gave me enough stimulation to stay firm in the tube, but not enough to get over the edge. The CB6KS is really a devious device! > The more I tried the less I got out of it. Felt good, but really frustrating! > I might add, the only way I can get in the CB is using the old sock trick. My thickness worked against me. I know that feeling!

I’ve found the new rings more comfortable than the older CB2K rings. Plus, there is very little cleanup of the mold lines needed. I could never get into the middle ring with the old CB2K, but I can slip right in with these new ones now. It’s so comfortable that sometimes I forget it’s even on. The only time I notice it at work is when lifting something and needing a quick adjustment; then everything is fine again. Standing up to pee works, provided the tube is completely full, but you have to drag the whole assembly out into view. Sitting down is much more practical.

Finally got all the adjustments right. I’ve been locked up since March 21st. I’m wearing the middle ring with the shortest pin and spacer. My testicles no longer escape. I plan to stay in as long as possible, only removing it once a week for cleaning and shaving. the referenced community page

href="httpthe Tickers Ticker

It’s getting more comfortable as time goes on. It comes off two or three times a week for cleaning and a quick shave. I went for about a five-mile bike ride and found a good position. No problems there at all, no chafing.

I’m past the one-month mark with no major issues. It gets a little dry around my scrotum while working, but I manage it. With warmer weather coming in, I might need to clean the tube every other day or daily. All in all, it’s been a very successful month. No testicle escapes and there is absolutely no way out.

Today has been the most comfortable day I’ve spent in this device!

I have been locked up for eight weeks today. No testicle escapes and no major problems at work. I even got a new pink lock for myself! A sissy should always wear some pink, don't you think?

Rode over twenty miles in my CB with no major issues this morning!